For high profile: Four load cell bolting-brackets are bolted to the outside of the SMH platform with two situated at the front underneath the table and the other two at the start of the tower. Angle bracket tracks are welded to the inside of the platform that acts as a cable protector for the scale and motor’s wiring. Scale weight capacity according to model specifications.
For low profile: A reinforcing base plate is bolted to the bottom of the base under the load processing area. Additional reinforcing tubes are welded to the sides of the base, not only adding to its strength, but also acting as cover protection for the cable wire that connects the load cells to the digital readout. There are four load cells and their respective spacer blocks bolted to each corner of the reinforcing base plate. For added protection, the load cells are covered with a formed steel plate. Must use a special scale ramp with this option.
Platform mounted load cells
Conveyor mounted load cells
Four load cells are bolted to the bottom of the conveyor legs. For added protection, the load cells are covered with a formed steel plate.
Sub conveyor platform mounted load cells